ELGO Electric P8721-000-R SERIES, Manual, Page: 15 / 35

15
6. Parameter table
Register Function Adjustment-Range Default Customer
01 Slow speed distance (forward) 0.1 mm 200*
02 Creep speed distance (forward) 0.1 mm 100*
03 Correction stop (forward) 0.1 mm 0
04 Spindle compensation 0.1 mm 50
05 Retract distance 0.1 mm 500
06* Tool Width /Tool offset 0.1 mm 0
07* Datum/reference value 0.1 m 1000
08 System Register 1 See Page 17 130000
09 Position reached pulse 0.1 s 10(0=held)
10 Backlash dwell time 0.1 s 10
11 Quantity reached pulse 0.1 s 10(0=held)
12 Tolerance window 0.1 mm 0
13 Min software limit 0.1 mm 0
14 Max software limit 0.1 mm 500000
15 Software limit disable 0,1,2,3 0
17 Display brightness 0-15 10
18 System Register 2 See Page 20 000001
19 Encoder pulse monitor time 0.1 s 0
20 Decimal point 3,0,2,1 0
21 Slow speed distance (only backwards) 0.1 mm 200*
22 Creep speed distance (only backwards) 0.1 mm 100*
23 Correction stop (only backwards) 0.1 mm 0
24 Window “forced loop” 0,1mm 0
25 Home position 0,1mm 10000
28 System Register 8 See Page 22 000000
29 Time delay for drive enable 0.1 sec 10
30 Time “Program-end” 0.1 s 10
31 Closed loop inhibit time in Hand 0,1 sec 10
33 Power on mode 0,1 sec 10
34 Start delay time 0,1 sec 10
40* Program Block selection See Page 12 1
41 Number of lines in Prog Block 1 – 99 20
46* Program counter Limit 1-99 0
47* Program cycle counter 0 - 9999 0
48 Program Counter timer (pulse time) 0 - 9999 0
56 Encoder edge multiplier 1,2,4 1
64 Direction of manual buttons 0-1 0
69 Speed of automatic reference run 0-2 0
88 System Register 4 See Page 24 000000
90 Button enable in service mode 0,1,2 0
94 Inch / factor multiplier 0.0to 9.99999 100000
96 Pulse factor for encoder 100000
97 Inch / mm conversion mode 0,1,2,3 0
98 Security code 250565 0
99 Service - - 0
* Logical sequence values such as these must always be present, regardless whether
3 speed, 2 speed or 1 speed drive is used.
P1 > P2 > P3 for 3 speed drive P1 = P2 > P3 for 2 speed or 1 speed drive.
Registers R6, R7 R40, R46 and R47 can be accessed and changed without need for Security Code.
The Registers R50 to 55, 57 to 63 and 65 to 68 are for analogue output only.