case, the signal configured by the user is output. Otherwise, the system waits
until the motion signal disappears and then outputs the signal configured by the
user.
The signal configured by the user is output for 500 ms each.
It must be ensured that no new movement is started before the signal
configured by the user has been triggered and that the signals Movement, Floor
level, Next stop are available.
Sensors
Load
Load[digit]
Available on fpc-01, fpc-02, fpc-04, fpc-05 devices
The widget Load[digit] displays the current payload of the lift in kg. To display
the measured values, the lift needs to dispose of a load measuring sensor that
provides the display the information via CANopen-Lift.
The Tara value, which can be defined in the CAN menu, will always be
subtracted from the shown value. If a load limit is defined in the CAN menu, the
respective message will be shown when the value is reached.
Load[needle]
Available on fpc-01, fpc-02, fpc-04 devices
The widget Load[needle] displays the current payload of the lift as a
tachometer. The background and the needle, as well as the range from
minimum to maximum, are freely configurable. To display the measured values,
the lift needs a load measuring sensor that provides the display the information
via CANopen-Lift.
The Tara value, which can be defined in the CAN menu, will always be
subtracted from the shown value. The defined overload value works as
maximum value for the scale. The dial must be set with this value.
© ELFIN Technology GmbH | flexyPage displays user manual | version 2.1.x | 2022-06
79
