Elettrotest 1K, User Manual

Page: 7 / 39

6
USER MANUAL RPS/M/1K
Elettrotest S.p.A. P.zza R. Riello, 20/B - 45021 Badia Polesine ( RO ) - tel. +39 0425 53567 - Fax +39 0425 53568
e-mail: info@elettrotestspa.it http: www.elettrotestspa.it
62000582 Rel.1.0 – 15/03/2018
1.9. NOTES FOR THE INSTALLATION
1.9.1. RPS/M/1K

Connect one supplying cable 2P+G (standard IEC cable) of suitable section (minimum
section 3x1.5 mm
2
).

Protect the input line with the circuit breakers presented in paragraph 5.

Connect load cable to the output connector. Use an appropriate sections according to the
maximum load tolerable by the RPS.

Put the ferrite core on the load cable close to RPS.

Optionally: Connect the sense wires.

Keep front area free for ventilation.

When RPS is mounted inside a cabinet you must install a forced ventilation in order to
expel the hot air.

Never lay power cables (including the electrical cables) and probe signal cables in the same
conduits;

Cleaning the device: When cleaning the device do not use ethyl alcohol, hydrocarbons
(petrol), water, detergents, ammonia and derivatives. Use only a dry cloth.
INPUT CONNECTOR OUTPUT CONNECTOR
FERRITE CORE