87
DEUT
SC
H
EN
GLISH
1. Turn the two spacers to the required
position (e.g.
Position A
in the picture).
The spacers are felt and heard to
snap into the separate positions.
NOTE
For the measurement process the spacers
at the required position have to fit closely
to the inside of the running edge.
1. Turn the two spacers to
position G
.
The spacers are felt and heard
to snap into position.
NOTE
For the measurement process the spacers must
lie on the running surface at
position G
.
5
Placing
RAILSTRAIGHT
on the rail
ATTENTION
After switching on,
RAILSTRAIGHT
carries out a
self-test. If
RAILSTRAIGHT
has contact with a rail
or other metallic surface during this process, the
app cannot connect to
RAILSTRAIGHT
. Do not
place
RAILSTRAIGHT
onto the rail or other metallic
surface before a connection has been made.
NOTE
Observe the rail type information
stamped on the rail in order to set up
RAILSTRAIGHT
for the right type of rail.
A list of the types of rail and the positions
of the spacers is available here:
Chap. 7 – Position of the spacers (table)
NOTE
With
RAILSTRAIGHT
DUAL the setting for the
rail is not required as the device simultaneously
measures the running surface and running edge.
5.1
Setting up
RAILSTRAIGHT
for running surface measurement |
W
C
5.2
Setting up
RAILSTRAIGHT
for running edge measurement |
W
C
