TURBINE UNLOCK PROCEDURE
Proceed as follows:
1.
Turn off the vehicle and pull out the key.
2.
Electrically disconnect the control of the variable geometry from the vehicle.
3.
Connect the clamps to the vehicle battery.
4.
Connect terminals +BATT and DRIVE of the signal generator to the control
of variable geometry.
5.
Set the frequency at 1Hz and duty cycle at 50%, then enable the generation
PWM CURRENT DRIVE and leave it for at least 10 seconds, then stop the
generation.
6.
Set the frequency at 10Hz and duty cycle at 50%, then enable the generation
PWM CURRENT DRIVE and leave it for at least 10 seconds, then stop the
generation.
7.
Repeat steps 4 and 5 at least 3 times.
8.
Disonnect the signal generator and restore the original connections of the
vehicle.
9.
Start the engine and accelerate slightly for 10s.
44
Summary of Contents for TwinProbe
Page 1: ...TwinProbe User Manual www elektropartner com...
Page 2: ...ENGLISH 5 en...
Page 3: ...2...
