ELEKTRO PARTNER TwinProbe, User Manual

Page: 30 / 50

10.3 Communication Mode with the Display Unit
The tool is not equipped with a user interface and the data acquired are
sent to an appropriate display unit.
Before starting the communication with the display unit, you
must perform the special configuration procedure.
The tool can be connected to the display unit in the following ways:
•
Bluetooth
•
USB
To make the most of the tool's potentials use USB connection, for a better
flexibility you are advised to use Bluetooth connection.
Power, connect and turn on the tool before starting up the
functions or software which will be used to interface with it. If this
procedure is not followed communication errors could occur..
The tool, upon switching on, identifies the communication mode to be used.
In details:
•
USB mode is started when, upon switching on, the tool is connected through
the USB cable supplied with the display unit switched on.
•
Bluetooth mode is started when, upon switching on, the tool is not connected
to a display unit through the USB cable.
To change the communication mode between the tool and the
display unit you must first turn off the tool and then choose the mode
you prefer.
29
en