4
for a special wipe to clean the lamp.
4. Only install Philips MSD 250 or MSD 250/2 GY9.5 lamp. Any other lamp is not acceptable.
Procedure:
1. Unscrew the 3 screws on the top of the housing. The lamp is underneath the plate. Carefully remove
the metal plate.
2. Then unscrew the 2 big screws and gently pull the socket holder using the knob in the middle.
3. Carefully insert the lamp into the socket making sure
the spring clips secure the lamp socket
correctly. Then insert the plate back into the fixture and fasten the 2 screws back in place.
4. On the plate there are 3 small screws marked 1, 2 and 3. These are used to adjust the lamp. You can
adjust the 3 screws to fine-tune the position of the lamp. In this way you can achieve the maximum
output from the lamp
.
Please remember the lamp is not a hot-restrike type. You must wait for approximately 10
Minutes, after having turned off the lamp, before you can turn it back on again.
Warning
-
Never ever operate the lamp when it is not inside the fixture. MSD lamps are volatile and could
possible explode. Only turn on the fixture with the lamp securely inside the fixture and the cover plate screwed
on.
B). Mounting MY 250.
Method 1: Installation using a C clamp.
The installation must always be secured with a backup safety attachment: namely an appropriate sized safety
cable. Don’t clamp the safety to a C clamp. That defeats the reason for a safety cable….namely a SEPARATE
backup to the primary hanging mechanism.
Never stand directly below the device when mounting, removing or servicing the
MY 250
.
Please make sure
MY 250
has been installed correctly both from a mechanical and electrical aspect before
powering up and operating for the first time. Spending a few extra minutes double-checking everything is better
than rushing to turn the fixture on.
Care should be taken to mount
MY 250
. Make sure that
MY 250
is mounted in such a way that no one can
touch it directly. For example, when hanging
MY 250
make sure it is high enough up not to hit anyone’s head or
run into any obstruction in its movement. Always keep
MY 250
away from any inflammable material.
Mounting
MY 250
is a job that requires qualified personnel with experience. If the personnel doing the
installation lack these qualifications do not use them to do the installation.