1
Introduction
Thank you for choosing
Elektralite’s MY 250
fixture.
Please read the User Manual carefully and keep it in a safe place after reading it.
MY 250
is very easy to install and use once you have read the manual. Failure to do so could result in damage
to the fixture, which will not be covered under warranty so please take the time to read it.
When you unpack
MY 250
you should find inside the box: the fixture, a 120 volt power cable, a 3 pin DMX
signal cable, a safety cable and of course this CD. Please check carefully that there is no damage caused by
transportation. Should there be any, consult your dealer immediately and
don’t
install it.
Features
Pan 630° / Tilt 265° with 16-bit resolution.
Speed control channel for Pan and Tilt.
Electronic focus.
8 colors plus white and rainbow effect
6 rotating gobos plus open white.
7 fixed gobos plus open.
Gobo shake and gobo indexing.
3 facet rotating prism with 16 in-built macro effects.
Strobe : with a frequency of 0~15 flashes per second with random function.
Dimmer 0 to 100%.
Automatic programs : 8 pre-built programs can be selected.
Display : digital address and function setting (also the display can be inverted if
fixture is hung upside down).
Local or remote resetting
Lamp switch ON/OFF locally
Auto test for all functions
Value of each DMX-channel can be displayed
Saved Program :
You can edit and save a program internally in the fixture by using either the
display panel of the fixture or using an external controller (your
Elektralite CP10xt or CP20xt
).
You
can save a maximum of 48 scenes. You can then run this saved program by using the “run” feature
from the menu on the display panel
SAFETY INSTRUCTIONS
A Word of Caution.
Please remember you will be working with 120 volts and you can suffer electric shock from any exposed lives
wires. So please be careful at all times and behave wisely.
Now you’re
MY 250
left
Elektralite’s
factory in perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely essential that the installer and user follow the safety instructions and
warning notes written in this user manual. Remember any damage caused by disregarding the manual or not
reading it, will not be covered by warranty and
Elektralite
(or any of its dealers) will not accept responsibility for
any resulting damage or problems.
If
MY 250
has been exposed to large environmental temperature changes in transit please do not switch it on
immediately it is unpacked. There maybe internal condensation. So leave
MY 250
off until it has reached the
running temperature of the venue.
Elektralite’s MY 250
needs to be grounded. Do
NOT
cut the ground pin or try to use two-core cable to connect
it to a 120-volt receptacle.
To be safe and to work properly you must have this fixture grounded.
A qualified electrician must do any electrical work.
