21
Channel 12 – Lamp on/off, reset, internal
0-19
color change normal by direction depend on distance
20-39
color change to any position by direction depend on distance
40-59 Lamp
on
60-79
Lamp switch off
80-99 Motor
reset
100-119
Internal program 1
120-139
Internal program 2
140-159
Internal program 3
160-179
Internal program 4
180-199
Internal program 5
200-219
Internal program 6
220-239
Internal program 7
240-255
Internal program 8
Channel 13 – Pan fine
Channel 14 – Tilt fine
ERROR MESSAGE
When you turn on the fixture, it will reset first. The display may show “Xer” while there are problems with one or
more channels. “XX” stands for channel 1,2,3,5,6,7 which has the testing sensor for positioning .
So, for example, when the display shows “02Er”, it means there is some error in channel 2. If there are errors
on channel 1, channel 2, channel 5 at the same time, you will see the error message “01Er”, “02Er”,”05Er” flash
repeated for 5 times. Then the fixture will generate a reset signal to all the stepper motors. If the error message
remains after performing reset more than 3 times, it will detect whether the fixture has more than 3 errors.
01Er:
Color wheel error. This message will appear after resetting
MY 250
and the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive circuit
on the main circuit board). Normally after a reset, the color wheel will go to its default position.
02Er:
Rotating gobo wheel error. This message will appear after resetting
MY 250
and the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive circuit
on the main circuit board). Normally after a reset, the rotating gobo wheel will go to its default position.
03Er:
Rotating gobo indexing error. This message will appear after resetting
MY 250
and the magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive
circuit on the main circuit board). Normally after a reset, the rotating gobo will go to its default position.
04Er:
Fixed gobo wheel error. This message will appear after resetting
MY 250
and the magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive circuit
on the main circuit board). Normally after a reset, the fixed gobo wheel will go to its default position
05Er:
Pan movement error. This message will appear after resetting
MY 250
and the yoke’s magnetic-indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive IC on
the main circuit board). Normally after a reset, the yoke will go to its default position.