22
06Er:
Tilt head movement error. This message will appear after resetting
MY 250
and the head’s magnetic-indexing
circuit malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive
IC on the main circuit board). Normally after a reset, the head will go to its default position.
08Er:
Prism wheel error. This message will appear after resetting
MY 250
and the magnetic indexing circuit
malfunctions (sensor failed or magnet missing) or the stepper motor is defective (or it could be the drive circuit
on the main circuit card). Normally after a reset, the head will go to its default position.
CLEANING AND MAINTENANCE
1. All bolts and safety chains must be tightly screwed into position and have no corrosion.
2. Regularly check all mechanic moving parts for wear. They must rotate freely and in no way stick or
squeak.
3. Regularly look for wear and tear on the 120 volt input cable and the DMX signal cable.
4.
Clean
MY 250
at frequent intervals. Use a moist lint free cloth. Do not use a wet cloth or a cloth with
alcohol or solvents added. Clean lens and the reflector when the lamp is off, disconnected from the
120 supply and when it is cool.
TECHNICAL SPECIFICATIONS
Power supply : 120VAC, 60Hz
Power consumption : max. 400 VA
Lamp : MSD250/2 GY9.5 socket, Metal Halide
Motors : 11 micro motors
Packing dimensions :66cm x 56cm x52 cm [26” x 22” x 21”]
Net weight : 25 KGS; 55 lbs
Gross weight: 29 KGS; 64 lbs.
[Errors and omissions for all information given in this manual is excepted.
All information is subject to change without prior notice].
Registering your MY250
It is very important that you register your
MY 250
so that you can receive any updates and have your warranty
in operation. To register please fill in the warranty form which can be found at
www.myelektralite.com
[Manual Updates. V1.12 = V1.1 + explanation of M10 bolts & insert on 3 to 5 pin DMX XLRs].
