2
Make sure that the power is only 120 volts. This unit will be damaged if you chose to install it at any other
voltage. In an installation it is always best to check the voltage before connecting. And remember never try to
connect you’re
MY 250
live.
Make sure that the power cable is not damaged and never break off the ground pin.
Always disconnect the power, when the device is not in use or before cleaning it. If you don’t then you are
wasting the lamp life. Merely closing the shutter just stops the light output, it does
NOT TURN OFF THE LAMP
.
Never try to disconnect you’re
MY 250
by pulling out the plug by tugging the cord.
Never touch
MY 250
when powered up. The lamp produces a considerable amount of heat and as a result the
housing does get hot. You can be burnt if you touch it.
Never look directly into the lamp source. Sensitive person could suffer an epileptic shock.
Never open
MY 250
and look at the lamp when the lamp is still on or when it is turned off but still hot or even
warm.
MY 250
uses a discharge lamp, which is volatile. The lamp can explode at anytime. Use extreme
caution and do not expose yourself to it. When replacing the lamp do not touch any glass part of the lamp. Only
handle by the silver terminal ends. Do not over tighten when installing a new lamp. Hand tight is more than
enough. PLEASE make sure that power to the fixture is
disconnected
and allow the fixture to
cool down
to
room temperature before installing a new lamp.
Please keep out of reach of the general public, children and animals.
