ELEKTRA VCD10, Installation Manual

Page: 17 / 72

Stage 6: Temperature
controller’s installation
The heating cable connection to the domestic
electric circuit should be performed by an author-
ised electrician.
The connection of the:
1. mains,
2. power supply conductors (“cold” cables) of
the heating cable,
3. temperature sensor.
in the installation box with the temperature
controller should be executed according to the
schematics included in the temperature control-
ler’s Instructions.
Note:
PE wires of the heating cable should be connected
to the protective (green-yellow) wire of the do -
mestic electric circuit via the dedicated terminal
“
╩
” in the temperature controller. If no such ter -
minal is present, the connection should be made
separately with a branch connector (connection
block) placed in the installation box.
If more than one cable has been installed in one
room, the cables must be connected in parallel,
i.e. the same type of cables (cables of the same
colour) should be connected to the same con-
troller’s terminal.
!
17