Electrolux EWM2000, Service Manual

Page: 33 / 74

ALARM CODES
SSD-P APdV, EB, HD 01/05
8.15
599 34 71-47
NO
YES
YES
NO
NO
YES
The door is felt open during the cycle or
remain close at the end of the cycle.
(1st page)
Checks to do:
E42
Unplug the connectors on
door lock and measure as
follow:
- Measure between
connector 3 and 5, you
should NOT find an open
circuit.
- Instead between connector
4 and 5, you should find an
OPEN circuit (numbers are
printed on the component).
Is the door lock OK?
3 Connections –Traditional
or instant door lock device.
- see pic. 17,18 -
To verify the cable measure the
following connections on main
board plugs:
- Measure between wire on J2-3
and J7, you should NOT find an
open circuit
-Measure between wire on J2-1
and J2-3, you should find an
OPEN circuit.
-Measure between wire J2-1 and
wire going to connector 4 in the
door lock, you should find a short
circuit.
Is the system OK?
- see pic.13, 16, 24 -
Change the door
lock and run the
diagnostic cycle
to measure any
further possible
alarm
Check/change the cables
and run again diagnostic
cycle to verify any further
possible alarm
Change the Door lock .
Is the machine working correctly?
Run again diagnostic cycle to
verify any further possible alarm
Verify mechanical coupling
between door lock and
door catch and eventually
change door catch/door
Is the door
lock with 3 or
4 connectors?
4 Connections
(Instant door lock
device)
- see next page (8.15) -
YES
If there are burn marks on
electronic board, see page 13.1-2