Electrolux EKC 603505, Instruction Booklet, Page: 33 / 80

electrolux 33
Electrical connection
Prior to making the electric al
connection, make sure that:
- The protection fuse and the domestic
wire system are suitable to carry the
total electric load of the oven (see
rating plate).
- Your domestic wiring system has an
efficient earth connection in
compliance with the rules and laws
in force.
- The wall socket or the omnipole
switch used for the electrical
connection can easily be reached
after the oven is built in.
The appliance is delivered without an
electric supply cable, therefore you will
have to fit to it a supply cable with
standard plug, suitable for the total
electric load shown on the rating plate.
The plug is to be inserted into a
suitable wall socket.
If you require a direct connection to
the electric network (mains), it will be
necessary to fit between the appliance
and the mains an omnipole switch, aith
a minimum gap between contacts of 3
mm. suitable for the required load and
in compliance with rules in force.
The green & yellow ground wire must
not be interrupted by the switch and it
should be 2-3 cm. longer than the other
cables.
The supply cable must in all cases be
laid out in such a way as to ensure that
it does not reach at any given point a
temperature 50°C higher than the
ambient temperature.
The manufacturer disclaims any
liability in case these accident-
preventing rules are not observed.