EDW1103
LED Test / Delete Alarm Memory
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S2 to start this function.
All used LEDS blinks 5 second on 1 second off.
If a buzzer is equipped, it beeps for 5 seconds.
The alarm codes saved in memory are erased.
2. Switching off the appliance will exit Service mode.
Functional Test Cycle
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S3 to start the test cycle. The cycle will not start if
door is opened.
L3 blinks for the duration of the test cycle.
The test cycle runs as a normal wash cycle. It can be
cancelled or run to its end.
Enable/disable Extra Rinse
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S1+S2 to enter this function.
L1 blinks indicating it is in Extra Rinse setting mode.
The Extra Rinse setting is shown by one of the indicator
LEDs on the right. LED off for disabled, on for enabled.
2. Press button S1 to change the setting.
3. Switching off the appliance will exit Service mode.
Enable/disable Pulse Wash
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S2+S3 to enter this function.
L2 blinks indicating it is in Pulse Wash setting mode.
2. The Pulse Wash setting is shown by one of the indicator LEDs
on the right. LED off for disabled, on for enabled. Press button
S2 to change the setting
3. Switching off the appliance will exit Service mode.
Technical Support – A.R.
Chapter
3.2
599 79 76 - 53 REV 1.0
