EDW1103
Access Service Mode
The Service Mode can only be accessed after the Reset function
has been carried out and the appliance is switched off.
Press and hold button S1+S3 simultaneously while turn the
appliance on, keep holding the buttons for 4 seconds.
L1, L2 and L3 blink to indicate that Service mode is accessed.
Alarm Reading and Actuator Test
After accessed Service mode (L1, L2 and L3 blinking):
1. Press button S1 to show the first alarm code.
L1 blinks to indicate the machine is in Alarm Reading.
The first alarm code is shown by blink sequences of 2
indicator LEDs on the right, while the upper one shows the
family code and the lower one shows the current alarm
code. Please see later Alarm Codes section.
2. Press button S1 again to show the second alarm code.
3. Press button S1 once more to show the third alarm code.
4. Press button S1 the fourth time to move to Actuator Test. Press
button S1 repeatedly will sequentially turn on one actuator at a
time.
L1 is turned off. L2 blinks to indicate the machine is in
Actuator Test.
The actuator number is shown by blink sequences of one of
the indicator LEDs on the right.
5. Press button S1 when actuator number 10 is activated, the
machine will cycle back to Alarm reading and show the first
alarm code saved.
6. Switching off the appliance will exit Service mode.
Number of
S1 Pressed
Actuator
Number
in Display
Actuator
Comment
4
4
Regeneration Valve
5
5
Drain Pump
6
6
Inlet Valve
Off when water
level reached
7
7
Heater
On only if water
level reached
8
8
Wash Pump
9
9
Dispenser
10
10
Dry Fan
Technical Support – A.R.
Chapter
3.2
599 79 76 - 53 REV 1.0
