Electrolux E9TB1-90BP, Manual

Page: 9 / 68

9 www.electrolux.com www.electrolux.com
CNT
KR
ID
TH
VN
EN
CNS
• Never operate the appliance without the lid.
• Do not use the appliance continuously for more than 3 minutes when processing heavy load. After
using for 3 minutes with heavy loads, the appliance should be left to cool for at least 20 minutes before
restarting.
• The appliance cannot be used for blending or grinding hard and dry substances, except for ice cubes.
• Be careful if hot liquid is poured into the appliance as it can be ejected out of the appliance due to a
sudden steaming.
• Never process boiling liquids (max 90°C).
• Do not exceed the maximum filling volume as indicated on the appliance.
• Do not use this appliance to stir paint. Danger, could result in an explosion!
• Do not let the power cord come into contact with hot surfaces or hang over the edge of a table or
counter.
• Never use accessories or parts made by other manufacturers not recommended or sold by Electrolux
as it may cause a risk of injury to persons.
• This appliance is for indoor use only.
• This appliance is intended for domestic use only. Electrolux will not accept any liability for possible
damage caused by improper or incorrect use.
• This appliance is suitable to operate on both 50 and 60Hz.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-out, this appliance
must not be supplied through an external switching device, such as a timer, or connected to a circuit
that is regularly switched on and off by the utility.
GETTING STARTED
Before using your appliance for the first time, remove all packing material such as plastics, stickers or
tags that may be attached to the components. Clean the appliance and accessories, see instructions:
“Cleaning and Care”.
Always prepare the ingredients: Rinse them thoroughly and cut them into 4 to 6 pieces and remove any
hard or large seeds. Remove any thick peel from the fruit or vegetables.
USING THE PRODUCT
1 Cleaning - Make sure that you start with a clean jug/jar, rinse the jug/jar before use.
2 Plug into mains
3 Maximum load
Blender - You can blend maximum 1.5L of ingredients with the blender, in order to avoid splashing
out ingredients. WARNING! We recommend to allow hot liquids to cool down (max 90 °C) before
filling the jug. Fill the jar only half full and start blending on low speed.
The blender jug can become very warm, operate with caution to protect your hands and to ventilate
steam out through the filler hole.
Chopper - You can chop maximum 0.4L of ingredients with the chopper, in order to avoid splashing
out ingredients.
Grinder - You can grind maximum 0.25L of ingredients with the grinder, in order to avoid splashing
out ingredients.
4 Jug/jar assembly
Blender - Blender - Place the lid on the jug, make sure that the lid is tightly fitted. Fit the measuring
cup in the lid by rotating clockwise until it clicks into position. You can add ingredients through the
filler hole newly added text translation required.
Chopper – Push the chopper gearbox into the chopper jug from the bottom and rotate it clockwise
until it clicks into position. Place the chopper blades on the tower in the chopper jug, and push
down the blades into position. Place the chopper lid on the jug and turn clockwise until it clicks into
position.
Grinde – Place the grinder jar with the open end up, and fill in the ingredients. Push the grinder
blade facing upwards in the grinder blade assembly holder until it is firmly sitting in its place. Turn the
blade assembly holder upside down, and screw it on the jar until tightly sealed. Turn the unit with the
ingredients upside down.