36
Service Information
46
Model
CLR2160
Self-Cleaning Cycle Instructions
To maintain operational efficiency, clean unit every six
months. (Depending on water conditions, more or less
frequent cleaning may be necessary.) If the ice maker
requires more frequent cleaning, consult a qualified
plumber to test the water quality and recommend
appropriate treatment. Use only U-Line Ice Machine
Cleaner (P/N 41978).
CAUTION
Use only U-Line Ice Machine Cleaner (P/N 41978). It is
a violation of federal law to use this solution in a
manner inconsistent with its labeling. Use of any
other cleaner can ruin the finish of the evaporator
and will void the warranty. Read and understand all
labels printed on the package before use. Ice
machine cleaner is used to remove lime scale and
other mineral deposits. Refer to the following steps
for mineral deposit removal.
1. Remove all ice from the storage bin.
2. Remove inside front cover by gently pulling away from
sidewall
(Figure 19)
.
Figure 19
3. Remove the overflow tube by lifting it up while using a
slight back and forth motion to loosen it from the drain
hole
(Figure 20)
. The water in the reservoir will flow
down the drain.
Figure 20
4. Replace the overflow tube after all the water has been
drained from the reservoir.
5. Hold down the ON/OFF key and press LIGHT three times
to enter cleaning mode.
6. When water begins to flow over the evaporator,
approximately three minutes, add one packet of U-Line
Ice Machine Cleaner to the reservoir.
7. Reinstall inside front cover.
8. When the self-cleaning process stops, approximately 45
minutes, it may be desirable to clean the storage bin.
See
Interior Storage Bin Cleaning
.
9. After one hour the display will change from “CL” back
to showing “ICE.” At this time the unit will
automatically begin normal operation.
Interior Storage Bin Cleaning
1. Disconnect power from the ice maker.
2. Remove any ice from the storage bin.
3. Wipe down the storage bin with a solution of
non-abrasive mild soap or detergent and warm water.
Rinse with clean water. Sanitize the bin with a solution
of one tablespoon of bleach and one gallon of water.
Rinse thoroughly with clean water.
4. Check that all drain connections are in place.
5. Reconnect power to the unit.
6. Make sure the drain system is working properly and the
drain hose is not pinched or kinked. Pour one gallon of
cool, fresh water into the ice bin. The water should
drain freely. If your CLR2160 is equipped with a drain
pump, the pump should drain the ice bin.
1
ULIN_0059_A
1
ULIN_0060_A
Use only Electrolux ice machine cleaner EIM41978.
E151M
Summary of Contents for E15IM60GPS
Page 47: ......
