iConserve User Guide___________________________________________________
12
the sensor may be cracked or damaged in some way. Check with customer service or your local
certified electrician.
Why is there a lower reading than what I expected?
If the cable is a very tight fit for the sensor, it is likely that the sensor is unable to close properly.
This may affect the readings.
If I remove the batteries, will I lose the information on the display?
No, if you need to change or remove the batteries, the display has internal memory, so
information stored will not be lost.
How do I reset the display (clear the data and start again)?
Press the mode and history buttons simultaneously and hold down for ten seconds.
I have three dashes (---) showing on the display. What does this mean?
Move the display unit closer to the transmitter and press the link button on the transmitter and
the search button on the main display unit. If the dashes remain on the display, this indicates
that the transmitter and receiver are not communicating. Please contact customer service to
help locate the problem.
How do I identify if the main display unit and transmitter working normally?
A. being the main display unit.
B. being the transmitter unit.
Normal Status will look like:
A. LCD display, with functional beeping buttons when pressed.
B. LED flashes (1 blink up to 64 seconds) on transmitter. Quick press on Check/Link button.
(On the side of the transmitter unit). Every 64 seconds the LED’s should blink.
Potential Problems:
Problem for A: No display, or displaying garbled characters (the value of abnormally large,
digital missing segment, multi-segment, etc.), or the keys give no reaction.
Problem for B: No LED flashes on transmitter.
Solutions:
Solution for A: Check if the battery is installed properly - Remove the battery, wait 10 seconds,
re-load a new battery according to polarity.
Solution for B: Check if the work environment is in line with product requirements - Avoid using
in harsh environments, such as extremely low temperature, high temperatures, or areas with
strong electromagnetic interference. (EMI)
Cost shows "----" and it seems the transmitter is not transmitting anything to the main
display unit?
Solutions:
Solution A: Re-load batteries of receiver and transmitter.
Solution B: Reset transmitters ID code:
Step1: Remove the batteries from transmitter. Two minutes later reinstall the batteries in the
transmitter.
Step 2: Remove the batteries from the receiver.