General control
We have programmed your blind to automatically stop at preset upper and lower stop positions. It couldn't be simpler- just press the
Up or Down button until the blind starts moving and your blind will move in the respective direction until it reaches the preset stop
position, where it will stop automatically. You can stop the blind at any point between the preset stop positions by pressing the middle
‘my’ button.
It is important that nothing is allowed to obstruct your Electra Honeycomb blind when moving. Should the blind be lowered onto an
obstruction, such as an ornament on a window sill, the blind will be impeded but the motor will carry on turning and the lift cords may
become entangled in the headrail. Repairs required for cords that have become entangled in the headrail are not covered by
guarantee.
Should the blind be lowered onto an obstruction first remove the obstruction and allow the blind to hang freely. Gently tug the bottom
bar to pull through cord that has unwound within the headrail. The bottom bar should be level. The blind may now be retracted.
Lowering the blind
Press the down button briefly to
send the blind to the lower stop
position.
Raising the blind
Press the up button briefly to
send the blind to the upper stop
position.
Stopping the blind
Press the 'My' button briefly to
stop the blind at an intermediate
position.
10
Operating your Honeycomb Blind
Summary of Contents for Honeycomb Series
Page 18: ...electrablinds co uk ...
