ELCOM Euro-2100, User Manual

Page: 35 / 68

Registration mode
Euro-2100 © Elcom, s. r. o.
35
Operation in registration mode
The functions that are described in the fol-
lowing chapters are used in the registration
mode. All financial transactions are stored in
this mode. If the cash register allows you to use the trai-
ning mode, you can try the following functions
in the training mode first (sales data are not
stored in the memory).
Recommended procedures at the beginning of the day
1) Check if there is enough paper on the prin-
ter roll for the day. Insert a new paper roll,
if necessary.
2) Print out an “X” report and make sure
that:
a) date and time are correct,
b) a daily report was executed.
3) Check whether there is enough cash in
drawer.
4) Register the initial cash put into the drawer
by pressing the ( RA ) key.
Printing modes
The Euro-2100 cash register allows you to cho-
ose a printing mode according to two basic cri-
teria: printing speed and power consumption.
One font is included in the Euro-2100; its he-
ight is 2.5 mm.
There are three printing modes in Euro-2100:
1) Normal normal printing saturation,
normal power consumption. This mode is
set as default.
2) Economical printing saturation is nor-
mal, the printing speed is a little bit lower
than normal. Power consumption is lowest
in this mode. This mode allows the longest
possible use of the cash register without an
external power supply.
3) High speed printing saturation is nor-
mal, printing speed is much higher than
normal. Power consumption is highest in
this mode. This mode takes advantage if
sales cadence is high. The discharge of the
internal lead-acid accumulator is much hi-
gher than in normal mode, so that the cash
register can work without external power
supply less time than in normal mode.
Programme the sixth system flag to set up the
printing modes.
If the cash register is not powered from an ex-
ternal power source (power adapter, car batte-
ry…), printing saturation may be a little lower,
depending on the charge of the internal accu-
mulator.
Status and functions required at the beginning of registration
If a key is used for two functions, choose the
function in the lower part of the key by simply
pressing the key and choose the function in the
upper part of key by holding the
( Shift )
key and pressing the key.
Error warning: the C
LEAR
key
If a function key is used incorrectly or the re-
gistration range is exceeded, the machine issues
an error beep and an error message appears on
the display. To recover and correct the condi-