elco RENDAMAX 30, Operating Instructions Manual

Page: 21 / 28

Set up
Display in operating field KM 628
1 Parameter display
P1 Current/set lead temperature
P2 Current/set hot water temperature
*P3 Desired lead temperature
P5 Current outside temperature
P6 Current exhaust temperature
P9 Current burner output
P10 Password
2 Optical interface
3 Reset / program button
4 Alarm LED
5 Parameter selector
6 Operating status outputs
7 Corresponding current measurement
8 Fault / parameter display
9 Operating status inputs
*) P3 desired load (for KKM cascade
manager)
Overview of the symbols
Input symbols
H
Flame ionisation in operation
RT Boiler released by external
regulator
Bus Data bus in operation
Output symbols
Main gas valve voltage on
Ignition transformer voltage on
Release of boiler ventilator
Z
Boiler pump voltage on
F
Hot water load voltage on
Setting the desired lead temperature
for heating operation
Only applicable without weather effect
of 0-5 V signal
x
Open flap (the arrow on the lower
side of the LCD display indicates
Parameter 1)
x
Press reset / program button (3),
Alarm LED lights up, turn the knob
(5) left or right until the desired
lead temperature appears in the
display
x
Press reset / program button (3),
Alarm LED turns off
x
Close flap
Setting the desired hot water
temperature for hot water use
Only applicable when using the boiler’s
hot water function
x
Open flap)
x
Turn the knob to the right until the
arrow on the lower side of the LCD
display indicates Parameter 2
x
Press reset / program button (3),
Alarm LED lights up, turn the knob
(5) left or right until the desired hot
water temperature appears in the
display
x
Press reset / program button (3),
Alarm LED turns off
x
Close flap
Information functions
(flap open)
Information menu
When the flap is open, turning the knob
(5) displays information. There are ten
menus. Using the knob, a selection
can be made. An arrow in the lower
section of the LCD display indicates
which parameter has been selected.
No. Parameter display
P1 Current / set lead temperature
P2 Current / set hot water
temperature
P3 Desired hot water temperature
(desired load for KKM cascade
manager)
P5 Current outside temperature
P6 Current exhaust temperature
P9 Current burner output
P10 Only for trained engineers
21