elco AEROTOP T Series, Planning Document

Page: 50 / 88

50
Outdoor Setup
Unit Dimensions AEROTOP T.. Outdoor Setup
50
AEROTOP T.. AEROTOP T..
Min. 1200 mm
Min. 800mm
4
5
AEROTOP T20-T35
AEROTOP T07-T16
AEROTOP T für Aussenaufstellung
AEROTOP T
Width
Height without
protective roof
Depth
Depth for
ASS
Height
at bottom
Height without
protective roof
on top
Setup
foundation
Feet
A B C C+ d e AS CS q
T07 995 1513 650 1450 575 910 1095 750 28
T10 1095 1563 750 1650 575 960 1195 850 28
T12, T14, T16 1195 1663 750 1750 575 1060 1295 850 28
T20, T26 1195 1690 880 1980 670 975 1295 980 45
T32, T35 1295 1900 1000 2200 670 1185 1395 1100 45
Minimum clearances for service works
Prevent air short circuits
Attention: a setup in the frontage corner leads to a
higher noise emission and should be avoided,
if possible!
1 Flow line heater ø 1” (ø 11/4” from T20)
Hydraulic and electrical connections all at the
bottom
2 Return line heater ø 1” (ø 11/4” from T20)
3 Condensation water drain ø 3/4”
4 Air
inlet
5 Air outlet
6 Electrical connections
a Electric line low voltage
b Electric line safety low voltage
7 Vibration dampening rubber feet
8 Protective roof with distance spacer
9 Setup foundation, minimum height 300 mm,
account for local snow heights.
AEROTOP T..Outdoor setup :
Incl. Hoods for Air In / Air Out, protective roof and
regulating wall housing.
The air discharge can’t be set directly on a wall. In
this case a minimum distance of 2 meters must be
respected.
The air suction and discharge must not be oriented
as the windflow. The correct functioning could be
compromised by the wind action.