elco AEROTOP T Series, Planning Document

Page: 41 / 88

Air Connections with Indoor Installation
AEROTOP T07-T35 with Noise Dampers (SI + SO) Corner Setup
41
AEROTOP T07 - 35 Corner Setup
The dimensions of the noise dampers
must be considered in addition when
placing heat pumps into a corner.
The heat pump can be placed in the
right or left corner. Air ducts are not
needed.
Required Accessories:
- AIR IN wall setup kit
- AIR OUT wall setup kit
- SI Noise damper
- SO Noise damper
1) The compliance with acoustic limit
values must be clarified by
customer.
AEROTOP T
Width Width Heigh
Dimensions With
Noise Dampers
Dimensions Of Both Cutouts,
Without Insulation
Minimal Dimensions,
Light Well
a b c A C a2 c2 d2 e2 x a3 c3 a4 c4
T07C, T07 995 1525 650 1570 1225 950 600 640 860 635 1200 600 800 600
T10C, T10 1095 1575 750 1670 1325 1050 700 640 910 635 1200 600 1000 600
T12, T14,
T16
1195 1575 750 1770 1325 1150 700 640 1010 635 1200 600 1000 600
T20, T26 1195 1675 880 1770 1455 1150 830 740 930 635 1400 800 1200 800
T32, T35 1295 1695 1000 1870 1575 1250 950 740 1140 635 1400 800 1200 800
•
Statistics to be checked by
customer If necessary wall must
be reinforced with PUR- insulation
elements. This must be considered
for the cutouts
The indicated cutouts apply only to the
accessories AIR IN and OUTLET wall
setup. The dimensions apply after all
tasks have been completed and refer
to finished floors.
2) Necessary outside insulation by
customer, minimal clearance of
light well must not be gone below.
3) Possible air short-circuit to be
prevented by customer.
4) Statistics to be checked by
customer
•
Possible air short-circuit to be
prevented by customer
•
Necessary outside insulation to
be installed by customer