elco AEROTOP T Series, Planning Document

Page: 44 / 88

Air Connections with Indoor Installation
Freely Selectable AIR IN
AEROTOP T07 - T16
44
The use of flexible air ducts offers a
variety of different air routing and
airflow options.
The flexible air out ducts are fastened
suction-side and with the intake box for
flexible air intake to the left or right side
of the heat pump.
The wall opening is insulated with the
corresponding insulation kit. Flexible ducts are not possible with
AEROTOP T 20 to 35 models and rigid
ducts must be used. See also "Parallel
Setup with Rigid Duct."
Required Accessories:
- Freely selectable AIR IN with air
duct
-
AIR OUT as needed, AIR OUT
wall installation or freely selectable
AIR OUT
1) The compliance with acoustic limit
values must be clarified by
customer.
2) Necessary outside insulation by
customer, minimal clearance of
light well must not be gone below.
3) Possible air short-circuit to be
prevented by customer.
5) Noise level of AIR OUT and AIR IN
must be considered separately
AEROTOP T
Cutouts Without Insulation
Cutouts With
Insulation
Recommended Light
Well Dimensions
c2 e2 d2
D2 with
rigid duct
e1 c1 c3
e3
T07C, T07 600 860 wählbar 620
800 540 800 600
T10C, T10 700 910 wählbar 620
850 640 1000 600
T12C, T12, T14, T16 700 1010 wählbar 620
950 640 1000 600
All dimensions refer to a finished floor and completed walls/masonry.
The duct can also be mounted to the
left or at the top of the heat pump
Necessary outside
insulation by customer