ELBUR: PB 521 II, PB 526 II
Elbur sp. z o.o. sp.k.
17 of 36
Check carefully marking on individual components to assembly nursing
bed in a proper way.
6.1. Location requirements
•
230 Volt power outlet (properly installed) must be available, near the
nursing bed in easily reachable position,
•
there must be enough space available for adjusting the bed, the space
under the bed must remain clear,
•
there must be enough space for operator or caregiver to look after
patient, at least on one side of bed.
6.2. Preparation
Before commencing assembly is necessary to:
•
bring the scissor lift, mattress support platform, end boards out of the
box,
•
bring all accessories, side rails, drive units and all other components
out of the box,
•
remove all unnecessary package’s items.
6.3. Assembly of mattress support platform
on the scissor lift
•
place the scissor lift on the flat, horizontal surface,
•
attach control box with the scissor lift by cable,
•
plug the mains cable and hand switch cable into
control box, than raise the scissor lift up to the
highest position using electric functions,
•
put two black rolls on external pins (upper part of
scissor lift),
•
foot section of mattress support platform insert
on just mounted black rollers,
•
push head section of mattress support platform
(look at labelling
: ‘HEAD SECTION’!
) into foot
section of mattress support platform to the limit
–
slide it parallel to
make sure they are not going to chock,
