ELBUR: PB 521 II, PB 526 II
Elbur sp. z o.o. sp.k.
13 of 36
Make sure when adjusting the bed that no patient, operator or any other
people, especially children can be jammed or injured.
The nursing bed must be cleaned and washed down with disinfectant
in case of a patient change or in other situation required it.
There must be a minimum height of 22 cm without compression
measured from the top of the mattress to the top edge of the top side
rail. This is illustrated on the pictured below.
1
–
mattress support platform, 2
–
foot end board, 3
–
head end board, 4
–
mattress,
G ≥ 22cm
When different mattress thicknesses are in use (thicker than 12 cm),
operator or person in charge has a duty to decide to undertake special
safety measures in order to prevent trapping or person completely falling
out in accordance to EN 60601-2-52. Do not hesitate to ask for an advice
Elbur customer service.
2.3.4. Assembly information
Warnings
Read instruction carefully before commencing assembly.
Verify the shipment contents with your order before commencing
assembly to make sure that you have got all necessary parts
and components.
Remember to use proper tools.
Two people qualified in nursing bed’s operating are required to assembly.
There must be enough space for bed height adjustment. It cannot be
blocked by any obstacles (bedside lockers or windowsills).
Make sure that cables connected control box with hand switch and other
drive units are not damaged, that there is no loop in the cables
and that they are not crushed by moving parts.
2.3.5. Service information
Warnings
Only specially authorized technicians are allowed to carry out
troubleshooting activities and replace individual electric components.
Use the test protocol draft on pages 28
–
31 during maintenance (you
can find it also on website www.elbur.eu)
–
the subsequent technical
safety check has to be documented. It has to be done at least once a
year and every re-use at the new place.
