5
4
Quick Start-up Guide
Connect your System
Using the GSM transmitter (SIM card)
Open the battery compartment at the back of the control panel and insert a SIM card in the
control panel.
Important
Before using the SS1 in GSM mode, you need to purchase a SIM card that works on the GSM
network with 850 / 900 / 1800 / 1900 MHz frequency. We recommend you to subscribe to a
plan with unlimited texts and one hour of voice. For more information, please contact your local
reseller.
Important
Make sure the SIM card does not require any PIN code. For more information, please contact
your local reseller.
Turning your System on
1.
Plug the AC adaptor to an AC socket.
2.
Plug the output connector of the AC adaptor into the
adaptor interface in the battery compartment at the back
of the control panel.
3.
T
urn the power switch to
"
ON
"
(in the
battery compartment at the back of the control panel).
Mount the Control Panel
Before mounting the control panel on the wall, make sure the reception of the GSM signal is
sufficient.
Fix the wall-mounting bracket on the wall with screws. Wedge the panel on the bracket, make sure
they fit well.
Basic Operations
Arm the System
Press the Arm button "
" on the control panel. The control panel beeps once: the system is
armed. The LCD display indicates "Armed" and the Arm icon on the control panel is lit.
Note
If the Entry / Exit Delay is activated, all zones except the 24h zone will be armed after the delay set
(refer to the instructions on page 10 of this manual “Entry / Exit Delay”).
Disarm the System
Type your user code and press the Disarm button "
" on the control panel. The control
panel beeps twice: the system is disarmed.
Home Mode
Press the Home button " " on the control panel. The control panel beeps once: the system is armed
in Home Mode.
All the sensors assigned to the Normal zone are armed. The sensors assigned to the Home zone
are disarmed.
Emergency Mode
Hold the “
#
SOS
” button for 3 seconds. The alarm is triggered immediately and the siren rings out.
At the same time, the control panel dials the stored phone numbers.
