29
28
Wireless Door / Window Contact
Features
This Door / Window Contact can be installed on doors, windows, and any other objects that
open and close. The sensor sends a signal to the control panel when the magnet is separated
from the transmitter.
Thanks to the tamper switch, any attempt to remove the cover of the Door / Window Contact
will trigger the alarm.
Design
Magnet
Transmitter
LED indicator
PCB Layout
LED working indicator
Zone setting
A23 12V battery
Tamper switch
LED indications
Blinks once: the door or window is open and the transmitter sends a signal to the control panel.
Blinks quickly: Low power indication, the batteries must be replaced.
Register in the control panel
Navigate through the menu of the control panel and reach "
ADD A NEW
" (Wireless Sensor).
Then separate the magnet from the transmitter to register the detector in the control panel.
To check if the registration is complete, arm the system and separate the magnet from the
transmitter again by opening the door or window on which it is installed. If the siren rings out,
the registration is successful.
Installation
-
Open the case and remove the battery activation strip.
-
Mount the sensor on the door and the magnet on the
door frame.
-
Make sure the magnet is placed above the transmitter.
-
Mount the magnet max. 1 cm away from the transmitter
and secure the transmitter and magnet with double-sided
tape or screws.
-
Avoid mounting the sensor in areas with a large amount of
metal or electrical wiring such as a furnace or utility room.
Specifications
Power supply
DC 12V (A23 12V Battery x 1)
Static current
≤ 30 uA
Alarm current
≤ 15 mA
Transmitting distance
≤80 m (in open area)
Radio-frequency
433 MHz (±75 KHz)
Housing material
ABS plastic
Operating conditions
Temparature: -10°C~55°C
Relative humidity: ≤ 80% (non-condensing)
Transmitter dimensions (LxWxH)
60 x 45 x 18 mm
Magnet dimensions (LxWxH)
45 x 19 x 17.5 mm
