EKOM DK50 S, Installation, Operation & Maintenance Manual

Page: 27 / 96

DK50
06/2008 - 27 - NP-DK50_2
E V1
U PE N
YV1
C
B1
2 U N X1 1
FU
3 4 X 2
1/N /PE ~ 230 V 50..60 Hz
ELECTRIC O BJECT O F 1st CAT.
B TYPE
SP
ST
40°C
p >
150°C
PE 1 2 3
U2 Z2
U1 Z1
M
D K50 Z, DK50-10Z, D K50 S, DK50-10S
EV1
U PE N
U N X1 1 2
FU
YV 1
B 1
C
B2
C
4 3 X2
SP
1/N /PE ~ 115 V 60 Hz
ELECTRIC O BJECT O F 1st CAT.
B TYPE
S T
40°C
p >
150°C
PE 2
1 3
U2 Z2
U1 Z1
M
D K50 Z, DK50-10Z, DK50 S, DK50-10S
ST Therm o sw itch YV1 Solenoid valve
SP Pressure switch Cb1 Capacitor
M M otor of com pressor FU Fuses , T10A
EV1 Fan of com pressor X1, X2 Term inal
ST Therm o sw itch YV1 Solenoid valve
SP Pressure sw itch Cb1, Cb2 Capacitor
M M otor of com pressor FU Fuses,T16A
EV1 Fan of com pressor X1, X2 Term inal
Dental compressor with a base DK50 Z, DK50-10 Z, DK50-10 Z/M (Fig.5) Place the product after
unpacking from the package with the base to the floor of the room, release it from all packaging material and
remove fixation parts (X,Y)- detail A.
Dental compressor in a box DK50 S, DK50-10 S Place the product after
unpacking from the package with the base to the floor of the room, release it from all packaging material and
remove fixation parts (X,Y)- detail A. Direct output pressure hose, sludging hose and power cord in the back
part of the compressor out of the compressor. Slide box from above to compressor so that front face is
directed towards a front part of the compressor and box stuffing fixes the base at its circumference.
Dental compressor in a cabinet DK50-10 S/M (Fig.3) From the top, put the
housing on the compressor, connect the flexible shaft to the control button, fasten with the screw and cover
the cabinet housing by the upper lid according to the picture.
Check whether pressure hose, sludging hose and electric cord are duly lead via rear opening at box. Grip
sludging hose with sludging valve in a holder at the rear side of a box.
10.2. Compressed air outlet
(Fig.6)
From the compressed air outlet (1) of the compressor, lead the pressure
hose with a nut (plow) fastened clip (3). Connect the hose to the appliance
– dental set.
10.3. Electric connection
Connect the network rope fork into the network plug.
Appliance is delivered with plug with protective contact. It is necessary to respect local
electrotechnical regulations. Mains voltage and frequency must comply with the data
stated at appliance label.
•
Socket must be well accessible due to safety reasons in order the appliance could be safely disconnected
from mains.
•
Corresponding current circuit must be safeguarded in the distribution system of electric energy by
max.16A.
Electric cord for the connection to mains and air hoses must not be broken.
11. WIRING DIAGRAMS
Fig.6