EKOM DK50 9x4VRT/M, User Manual

Page: 7 / 45

DK50 9x4VRT/M
10/2018 NP-DK50-9x4VRTM_ED-EN-2_10-2018
- 7-

product. The user must be trained to
operate the product and must be
experienced.

Create operating regulations for the person
operating the product.

Wear hearing protection when starting the
product, during operation and any time it is
in operation.

Operating the product in operating
premises that may contain mixtures of
flammable gases such as operating rooms
or in areas that may contain explosive
mixtures of particulate, such as coal dust,
is prohibited.

Flammable materials pose an explosion
hazard!

Use of the product in wet or damp
environments is prohibited.

The user shall inform the supplier
immediately if any problem occurs in direct
connection with the operation of the
equipment.
5.3. Electrical system safety warnings

The equipment may only be connected to a
properly installed socket connected to earth
(grounded).

Before the product is plugged in, make
sure that the mains voltage and frequency
stated on the product are the same as the
power mains.

Check for possible damage to the product
and the connected air distribution system
before use. Replace damaged pneumatic
and electrical conductors immediately.

Immediately disconnect the product from
the mains in hazardous situations or when
a technical malfunction occurs.

During repairs and maintenance, ensure
that:

product is disconnected from the
mains

pressure is released from all lines

Only the manufacturer, or a qualified
specialist trained by the manufacturer may
install, modify or upgrade the product itself.

Only a qualified electrician may install
electrical components!
6. STORAGE AND TRANSPORT
The compressor is shipped from the factory in
a transport packaging. This protects the
device from damage during transport.
The original compressor
packaging must be used for
transport whenever possible. The
compressor is to be shipped in a
vertical position and must be
secured using transport straps.
Protect the compressor from humid
and dirty environments and extreme
temperatures during transport and
storage. Store a compressor in its
original packaging in a warm, dry and
dust-free area. Do not store near any
chemical substances.
Keep packaging material if possible.
If not, please dispose of the
packaging
material in an
environmentally-friendly way.
Packaging cardboard can be
recycled with old paper.
The compressor must be
transported only when all air has
been vented. Before moving or
transporting
the compressor,
release all the air pressure from
the tank and hoses and drain the
condensed water.
Ambient conditions for storage and
transport
Products may only be stored and transported
in vehicles that are free of any traces of
volatile chemicals under the following
conditions :
Temperature : +0°C až +50°C,
Max. relative humidity: 90%,
