EKOM DK50 2V/50/M, User Manual

Page: 29 / 220

INSTALLATION
03/2022 29 NP-DK50 2V 50, 2x2V 110-AD-A-1_03-2022
INSTALLATION
Risk of incorrect installation.
Only a qualified technician may install the compressor and place it into
operation for the first time. Their duty is to train operating personnel on the use
and maintenance of the equipment. An entry is made in the equipment
installation record to certify installation and operator training. (see the Annex
chapter)
9. INSTALLATION CONDITIONS

The compressor may only be installed and operating in dry, well-ventilated and clean
environments under the conditions specified in the Technical Data chapter.
Risk of damage to the device.
The equipment may not be operated outdoors or in otherwise wet or damp
environments.
Risk of explosion.
Do not use the equipment in the presence of explosive gases, dust or
combustible liquids.
Burn or fire hazard! Caution! Hot surface!
Portions of the compressor, dryer may be hot and reach hazardous
temperatures during compressor operation that may harm materials or
operating staff.

The compressor must be installed so that it is accessible at all times for operating and
maintenance. Please ensure that the nameplate on the device is readily accessible.

The compressor must stand on a flat, sufficiently stable base (be aware of the weight of the
compressor, see the Technical Data chapter).
High temperature hazard.
The placement of air flow impediments upstream or downstream of the cooler is
prohibited. The temperature of internal and external parts of the cooler may be
hot and reach hazardous temperatures.
You may notice a “new product” odour when you first place the product into
service (for a short period of time). This odour is temporary and does not impede
the normal use of the product. Ensure the space is properly ventilated after
installation
.
10. COMPRESSOR ASSEMBLY
10.1. Handling and releasing the compressor

Unpack the compressor from the packaging.

For a compressor with a cabinet, remove the door held on the screws and for DK50 2V/50/M
compressors, remove the connecting strip (17) in the lower part of the cabinet. Remove the
cabinet from the compressor.

Detach the compressor from the pallet: for DK50 2V/50/M compressors, loosen the screws and
for DK50 2x2V/110/M compressors, loosen the straps (Fig. 5)

Position the compressor at the site of installation. (Fig. 6)