EKKO ES100E, Operator'S And Service Manual

Page: 25 / 65

Function Test
23
Emergency stop
16.Push in the platform red Emergency Stop
button
to the “off” position.
⊙
Result: No functions should operate.
17.Pull out the red Emergency Stop button to
the “on” position.
⊙
Result
：
The LED diagnostic reading device
led will turn on.
Test the horn
18.Press the horn button
⊙
Result: The horn should sound
.
Test the Function Enable Switch
and the Up/Down Functions
19.Do not hold the function enable switch on
the control handle.
20.Slowly move the control handle in the
direction indicated by the blue arrow, then
in the direction indicated by the yellow
arrow.
⊙
Result: No functions should operate.
21.Press the lift function button.
22.Wait seven seconds for the lift function to
time out.
23.Slowly move the control handle in the
direction indicated by the blue arrow.
⊙
Result
：
The platform should raise. Pothole
protection device should be expanded.
24.Release the control handle.
⊙
Result
：
The platform should stop raising.
25.Press and hold the function enable switch
on the control handle. Slowly move the
control handle in the direction indicated by
the white arrow.
⊙
Result
：
The platform should lower. The
descent alarm should flash and sound
while the platform is lowering.
Test the steering
Note: When performing the steer and drive
function tests, stand in the platform facing the
steer end of the machine.
26.Press the drive function button.
27.Press and hold the function enable switch
on the control handle.
28.Press the switch on top of the control
handle in the direction indicated by the left
triangle on the control panel.
⊙
Result: The steer wheels should turn in the
direction indicated by the left triangle.
29.Press the switch on top of the control
handle in the direction indicated by the
right triangle on the control panel.
⊙
Result: The steer wheels should turn in the
direction indicated by the right triangle.
Test drive and brake
30.Press the drive function button.
31.Slowly move the control handle in the
direction indicated by the up arrow on the
control panel until the machine begins to
move, then return the control handle to the
center position.
⊙
Result: The machine should move in the
direction that the arrow points on the
control panel, then come to an abrupt stop
when the control handle is returned to the
center position.
32.Press and hold the function enable switch
on the control handle.
33.Slowly move the control handle in the
direction indicated by the down arrow on
the control panel until the machine begins
to move, then return the control handle to
the center position.
⊙
Result: The machine should move in the
direction that the down arrow points on the
control panel, then come to an abrupt stop
when the control handle is returned to the
center position.
Note: The brakes must be able to hold the
machine on any slope it is able to climb.