Application manual
KNX standard wall presence detector with movement function EK-SN2-TP-
…
Rev. 1.0
– 29/09/2022
MAEKSN2TP_EN
© Ekinex S.p.A.
– All rights reserved
Pag. 20
Parameter name
Conditions
Values [Default]
Test mode
Device type = Master
Disable
Enable
If enabled, test mode is activated after the program download and exits automatically after 10 min. Then
enters into auto mode or semi-auto mode according to the setting
item of “Auto-Semi-auto select”.
If test mode function is activated, once the movement is detected, both the load and LED will be 2 sec on
and 2 sec off.
Sensor sensitivity
Maximum
High
Medium
Low
OFF
It is used to increase or decrease the sensitivity of PIR in the device. The sensitivity can be adjusted
according to user’s requirement no matter the detector is master or slave.
Maximum: Highest sensitivity
High: Higher sensitivity
Medium: Medium sensitivity
Low: Lowest sensitivity
OFF: Detecting function of PIR is deactivated
LED turns on when PIR is
triggered
Disable
Enable
It is used to set the switch on of the indicator LED when PIR is triggered.
When enabled, the red LED will turn on for 1 s every time movement is detected. This indication can be
suppressed (disable); however, all other indication functions of the LED remain enabled.
14.3 Menus: Light control output C1 / C2
Following parameters are repeated for each of the two Light Control channels C1 and C2
.
Although not specified below, these options are only listed if the corresponding channels are active.
Figure 18 - Light control output C1 / C2
– Switching parameters
