Ekinex EK-SN2-TP-GAA, Applications Manual

Page: 13 / 29

Application manual
KNX standard wall presence detector with movement function EK-SN2-TP-
…
Rev. 1.0
– 29/09/2022
MAEKSN2TP_EN
© Ekinex S.p.A.
– All rights reserved
Pag. 13
Warning:

Do not mount on conductive surface.

Do not open the enclosure frequently.

The sensor is a low voltage circuit; never connect it with the 230V line network.

Do not run the KNX wiring in the same conduit used by line network wiring.
11 Connection of the KNX bus line
The connection of the KNX bus line is made with the terminal block included in delivery and inserted
into the slot of the housing. At this point it is recommended to carry out the commissioning of the
device (see “Commissioning”), or at least the download of the physical address, using the pro-
gramming button placed close to the bus connector.
12
Configuration and commissioning
Nota: The configuration and commissioning of KNX devices require specialized skills.
To acquire these skills, you should attend the workshops at KNX certified training
centers.
Con
figuration and commissioning of the device require the use of the ETS
®
(Engineering Tool
Software) program V5 or later releases. These activities must be carried out according to the design
of the building automation system done by a quali
fied planner.
For the con
figuration of the device parameters the corresponding application program or the whole
ekinex
®
product database must be loaded in the ETS
®
program.
Code
Application program
(## = release)
EK-SN2-TP APEKSN2TP##.knxprod
For the commissioning of the device the following activities are required:

make the electrical connections as described above;

turn on the bus power supply;

switch the device operation to the programming mode by pressing the programming
pushbutton; the blue programming LED (visible through the device lens) turns ON;

download into the device the physical address and the con
figuration with the ETS
®
program.
At the end of the download, the operation of the device automatically returns to normal mode. During
the programming process, the programming LED is turned o
ff.
Now the bus device is programmed and ready for use.
i