Connecting
5.2 Connector locations
18
CuratOR LX491W
Instructions for Use, 02/2018
NOTICE
Cable installation
Observe the following instructions:
• Only shielded cables are to be used for all signal connections.
• If the relevant facility is available on the connector, all plug connections must be
screwed tight or locked.
• The connecting cables must not be kinked.
• The minimum bending radius of a connecting cable generally equals five times the ca-
ble diameter.
• Do not route signal cables and power cables next to one another. Otherwise, line power
subject to heavy interference could result in reversible pixel errors.
• The device must not share a line power supply with motors or valves (interference!).
• Externally connected cables can represent a trip hazard. Make sure that all incoming
cables are safely routed.
• If the device offers strain relief mechanisms for the cables, use them to prevent unin-
tended loosening of connected cables.
5.2 Connector locations
The connectors are located in the connection panel behind a cover on the back of the moni-
tor. The power switch is not covered and is freely accessible.
&RYHU
6FUHZFRYHU
6FUHZFRYHU
Fig.:
Rear view with cover
Summary of Contents for CuratOR LX491W
Page 69: ......
