eInstruction Interwrite Board, Training Workbook

Page: 4 / 60

________________________________________ Workspace Level 1 Training Workbook
4
Set Up the Hardware
The Interwrite Board
Your Interwrite Board has several pieces. Make sure all pieces are connected and the pens
are charged before connecting to your computer.
1. Attach the Bluetooth module to the board and then connect it to the
controller on the back of the board.
2. Attach the pen charger to the board and plug it into the controller on
the back of the board.Green lights should appear to show the pens are
charging .
3. Connect the power cord to the board and an electrical outlet; then turn the board on
using the rocker switch on the side of the board.
4. Turn on your projector , make sure to line up the image
within the four tick marks found within the corners of the board.
The Interwrite DualBoard
Your Interwrite DualBoard has several pieces. Make sure all pieces are connected and
the pens are charged before connecting to your computer.
1. Plug the RJ12 connector on the RFCOM cable into the RJ12 COM Port on the top of
the Interwrite DualBoard controller box on the back of the board.
2. Slide the RFCOM holster over the board’s frame at the top of the board.
3. Seat the RFCOM in the holster.
4. Plug the Workspace RF Hub into a USB port on your computer or USB hub.
You should be aware that the RF Hub works best when it is
not
plugged
into a computer that is under a podium or a desk. If necessary, use a USB
extension cable to get your RF Hub out from under furniture that may
shield the RF signal.
5. Turn on your projector , make sure to line up the image within the four
tick marks found within the corners of the board.
RFCOM
RFCOM Holster