35
5.8.3 Installing and removing the EBP
1
Remove the marine connector protector or, if a cable is attached to your Scuba, remove the locking sleeve and then
the cable.
2
Clean the connectors on the EBP and Scuba and add a little silicone grease to each.
3
Find the white dot on the hexagonal sleeve on the bottom of the EBP and note that the Scuba connector has six pins
with a gap in the outer circle of pins.
4
Line up the white dot with the gap in the connector pins and slowly push them together. Very little force is needed.
5
Grasping only the Scuba and EBP locking sleeve (the portion of the lower EPB with the serrations), turn the
EBP locking sleeve so that it screws into the threads where the underwater cable locking sleeve is normally
fitted. You may have to jiggle the EBP a bit so that the hexagonal sleeve fits properly over the hexagonal base
of the connector.
locking
sleeve
white dot
gap in
connector pins
