Efiamma Good 10 C, Use And Maintenance Manual

Page: 46 / 156

GOOD 10 C- GOOD 12 C
Use and maintenance manual
Page 46
Rev.0 01/03/2019
EN
This type of installation (See Fig.6) requires a horizontal section to connect to a pre-existing chimney pot.
Respect the slope indicated in figure, in order to reduce the ashes depositing in the horizontal tube. In the lower part of the chimney
pot, there is a "T" type fitting installed with inspection cap, in the same was as the chimney pot opening.
It is prohibited to install a 90° bend for the initial segment, since the ashes would quickly obstruct smoke passage, causing draught
problems in the stove. (See Fig.2)
IT IS MANDATORY TO USE STAINLESS STEEL AIR-TIGHT TUBING WITH SILICONE OR VITON
®
GASKETS.
2 - 3 mt max
Height exceeding 4 mt
Slope 3 - 5 %
Max 2 -3 mt
INTERNAL
CHIMNEY
Fig.6
T fitting for condensation
Inspection hatch
Protection from rain
Hot air ducting
The stove is equipped with a rear outlet (model 10 C) or two rear outputs (model 12 C) of 80 mm (outside diameter) to allow the ducting of
hot air flows to other rooms.
To create the ducting system:
- use pipes with internal diam. of 80 mm able to resist temperatures of at least 150°C;
- use pipes that are smooth inside, insulated or isolated;
- reduce, as far as possible, the ducting path and the single pipe section must not be longer than 6 m;
- avoid constrictions or section reductions, tight bends and downsloping sections.