Eelectron Spa
IN00B02WEBFI00070102_ADMIN_MANUAL_EN.DOCX
61/113
The first part of this configuration page contains all specific settings regarding the object itself. In
BASE mode the following settings are accessible (as also shown in the screenshot):
NAME
Name of the object, which identifies it within the software. During the
import process, the name of the corresponding group address from the
ETS project is taken over; this setting can be changed here, if needed.
GROUP ADDRESS
Main group address used by the object for the communication with the
KNX
bus; this setting can’t be changed, but its value can be used as
keyword for the search engine.
FUNCTION
Category to which the object belongs to; the selection here determines
which icons are available in the next option. It is also possible to assign
the object to no function, if the object should not be listed inside any
FUNCTIONS page in the FRONT END.
ICON
In a popup window the icon can be selected, through which the object
will be shown in the FRONT END. The available icons depend on the
type of the KNX object and the function assigned to it. If "None" is
defined as function, all icons matching the type of the KNX object will
be available.