Eelectron Spa
IN00B02WEBFI00070102_ADMIN_MANUAL_EN.DOCX
66/113
KNX Devices
HORIZONE SERVER
makes it possible to control the installed physical KNX devices of the system
and to
send out a warning when devices are not communicating anymore.
The installed KNX devices are created automatically during the import of the ETS project. At the
end of the import proce
dure, the devices will be listed in the BACK END in “TECHNOLOGIES“
“KNX“ “KNX DEVICES“ (click on the 3 points beneath the title in order to get a listing of the
present KNX devices, as shown in the screenshot on the next page):
If you want to access the settings window of a single KNX device, you can either do that by clicking
the “EDIT” button on the entry of the navigation menu or by clicking on the “EDIT” button (green)
present in the listing of the devices. The column “STATE” in this listing shows information about the
related KNX device:
N.A.
The device has never been reached / never answered a request. It is
possible that it is not installed in the system yet
OK
The device answers the requests of
HORIZONE SERVER
correctly
and is communicating normally
TEST RUNNING The device has been reached and the server is currently waiting for
its reply
NO ANSWER
The device has answered past requests correctly, but is currently not
reachable anymore and therefore not communicating
The requests are sent to the KNX devices automatically; the single devices are requested one after
another, which keeps the traffic on the bus on a low level.
