EDWARDS SYSTEMS TECHNOLOGY IRC-3, Programming Manual

Page: 106 / 284

2.62 Programming Manual
CM2(N) to an IBM PC compatible computer. Select 6) Download
Database from the menu.
Before data can be transferred, the following steps must be taken:
1. When loading data to the CM1(N)/2(N) for the first time, all ZAS
Cards located in the CM1(N)/2(N) motherboard (slots P5 and P6)
MUST be removed prior to loading data.
2. Connect the download cable to the RS-232C port on the
CM1(N)/2(N) panel.
3. Place the CM1(N)/2(N) in the program mode.
The base Panel Address must be assigned to the CM2(N) by physically
downloading directly to the CPU card. After a CM2(N) contains it's
base Panel Address, the entire database can be downloaded from the
CM1(N).
Note:
Different methods are available to program the panels of the
Network. Each IRC-3 CPU Card must be initially programmed for a
base Panel Address. If the program cable and IBM compatible
computer is connected at the CM1(N), it may be easier to place each
CM2(N) CPU Card one at a time in this panel for the programming
process. If you use the CM1(N) to do all of the panel program loading,
you must use a cover for a CM2(N) during this process. Refer to
Chapter 3 of this manual for more information concerning the CM1(N)
and CM2(N) program modes.
After selecting 6) Download Database from the menu, the following
screen is displayed:
firealarmresources.com