2. Press the Other Areas "Phone" switch. The Other Areas Phone LED
will light. The phone risers are now connected to the Other Areas
(channel 2) pre-amp output.
3. Any active phone station on either phone riser may make an
announcement to the selected areas. The FCCA master handset may
be used to monitor this announcement. The page message will
automatically override any tone/tape message being broadcast.
To make an ALL CALL phone page:
1. Establish two-way communications with the phone station which
will make the page.
2. Press the Fire Area and Other Areas "Phone" switches. The Phone
LED’s will light. The phone risers are now connected to the Fire
Area (channel 1) and the Other Areas (channel 2) pre-amplifier
outputs.
3. Any active phone station on either phone riser may make an
announcement to all areas. The FCCA master handset may be used
to monitor this announcement. The page message will automatically
override any tone/tape message being broadcast.
Tape Message
To broadcast the pre-recorded message:
1. Press the appropriate Tape switch. The respective Tape LED lights.
The Aux Input (tape) is now connected to its respective pre-amp
output, and activated.
Note:
MIC or Phone Page will override the tape message.
Tone
To broadcast the tone signal:
1. Press the appropriate Tone switch. The respective Tone LED lights.
The fire or other area internal tone generator is now connected to its
respective pre-amp output, and activated.
Note:
MIC or Phone Page will override the tone.
FCCA Series Manual
13
firealarmresources.com
