Edgewater Networks 240IS, Owner'S Manual

Page: 27 / 219

25
Upholstery
Soap and water should be periodically used to clean the vinyl. Vinyl protector products can make the
seats slippery, which may not be desirable. When cleaning the vinyl, be gentle. Do not use cleaners
that contain ammonia, acetone, strong solvents, or powdered abrasive cleaners. They can damage and
shorten the vinyl’s life.
Sump Area
Your EdgeWater has a bilge area in the after part of the boat. This can be maintained well by
periodically using a boat bilge cleaner. Follow the directions carefully.
10.2 Engine
If you have a new engine with a built-in flushing device, the engine may be flushed without cranking. If
the engine does not have a built-in flush device, one may be purchased to fit.
To flush the engine, after connecting a water hose to the proper connection, turn on the water. Put the
engine control in the idle position and crank the engine. Only let it run a couple of minutes. The gear
case is water-cooled and is not designed to run out of the water for extended periods.
Do not crank the engine without water running. Water acts as a coolant and also a
lubricant for the water pump.
Do not rev the engine when flushing; idle speed is sufficient!
The exterior of the engine will respond well to a good quality wax. This should be re-applied every
several months as the marine environment is a very harsh one and the constant sun exposure will
deteriorate your motor’s finish. Consult the engine manufacturer’s owner’s manual for specific
instructions. In areas where there is a conflict between this manual and the engine manufacturer’s
manual, the engine owner’s manual will take precedence.
11/ Exterior Equipment
11.1 Anchor Locker
The anchor locker on your new EdgeWater 240IS has been designed for a danforth style 8 S anchor.
On the 240IS the anchor locker is located forward on the centerline. Before using the anchor for an
extended period or overnight, make sure the free end of the anchor line is shackled to the boat’s
forward eye. On the 240IS your anchor line should have a shackle attached to the free end which is
then attached to the eye in the anchor locker at all times.
Remember, your anchor line should be a minimum of 7 times the depth in which you
routinely operate.