Edgewater Networks 240IS, Owner'S Manual

Page: 28 / 219

26
Your EdgeWater 240IS should have a minimum of 150 to 200 feet of ½” three strand nylon
line. If you routinely venture offshore, remember the 7 times depth rule. This may sound
like a lot but if your engine fails in 100 feet of water, maintaining your position will be very
important to being recovered.
11.2 Swim Platform
(optional)
If your EdgeWater 240IS is equipped with the optional swim platform, there are several
important things to remember for safe use and operation of this useful option.
•
Always shut down the engine if persons will be using the platform. Do not just settle for
the engine being in neutral.
• Make sure the folding ladder portion has been properly stowed before getting
underway.
12/Seasonal Maintenance
12.1 Engine
Refer to your engine manual for any specific information pertaining to your engine. For the fuel system,
add a fuel stabilizer to a full fuel tank as per the stabilizer’s instructions. Run the engine for a
minimum of 10 minutes to allow the fuel stabilizer to reach the engine.
•
Wax the engine exterior.
•
Remove the engine cowl and spray the engine’s powerhead with a non-conductive lubricant spray. Do
not spray directly on joints that are lubricated with grease as some lubricant sprays may dissolve
grease.
•
Grease all external zert fittings on the engine and steering system. Use a grease that is consistent with
engine manufacturer’s recommendations.
•
Change the engine lower unit lubricant. This will remove contaminants that may have built up
throughout the boating season. This is also a good time to check for lower unit seal problems. If there
is a leak, have it repaired by your dealer.
•
Remove the propeller and grease the propeller shaft. Inspect the shaft and propeller for unusual wear
or signs of deterioration.
12.2 Hull
•
Wax the entire boat. The hull will maintain its factory delivered luster much longer if waxed at least
once a season. The inside of the boat, which is subject to the sun’s direct rays, will also respond well to
a good coat of marine wax.
DO NOT wax the non-skid surfaces.
•
Remove the hull plug so the sump area can breathe.