Manual
CERÂMICA
7-4)
Next the display will show “C-01”, which is the
number of the ceramic standard recipe that serves as a
base for programming the next recipes. The arrows (09)
below the number will be used to select the desired
recipe, in this case (01).
LER RECEITAS
7-5)
Confirm the reading operation activating the “Ler”
(“read”) key (15) this message will be kept on the display
while the recipe is being loaded.
7-6)
Start the programming for a new recipe taking as base the ceramic standard
recipe that has been loaded in the memory.
7.
7
T1 And T2 Temperature adjustment
7-8)
Temperature adjustment - T1
Activate the T1 (11), key and the display will show the
programmed temperature of the standard recipe that
comes from the factory “0600”.
PROG - TEMP - T1
7-9)
Next, activate the parameters adjustment keys (09),
one for each digit showing on the display the desired
value for T1 of 0620°C. The furnace will heat until this
temperature.
TEMPERATURA - T1
7-10)
Temperature adjustment – T2
Activate the T2 (10) key, and the display will show the
programmed temperature of the standard recipe that
comes from the factory “0960”.
PROG - TEMP - T2
TEMPERATURA = T2
7-11)
Next, activate the parameters adjustment keys (09),
one for each digit showing on the display the desired
value for T2 of 0900°C.
10
Summary of Contents for Fv Plus Sinter
Page 1: ...Manual CAPA ...
