ECTACO Partner
®
X8
User's Manual
10
♦
Note:
Never try to remove the batteries from the device when the
power is on. This can seriously damage the device. If you
experience difficulties turning the device off, press the RESET
button on the right-hand side of the keyboard (above the
button) and reinstall the system.
•
Remove the battery compartment cover by sliding it away from
the device.
•
Remove the used batteries and replace them with new ones.
♦
Note:
Do not mix old and new batteries.
•
Make sure to place the batteries according to the polarity marks
(+ -) inside the compartment.
•
Put back the battery compartment cover by sliding it toward the
device. Make sure the cover sits in place properly.
•
Turn the device on to make sure it works correctly.
♦
Note:
You have two minutes to replace the batteries without risk
of losing the data stored in RAM.
Do not exceed the two-
minute limit!
Neither the manufacturer nor the dealer may be
held responsible for the loss of user data.
Initialization
The initialization routine is started:
•
when the ECTACO Partner
®
X8 is turned on for the first time;
•
when you remove the batteries (e.g. when replacing them)
for longer than two minutes;
•
after the system has been reset with the RESET button.
♦
Note:
The RESET button is located on the right-hand side of the
keyboard (over the
button). It can be accessed with any thin
object like a paper clip. Never use a needle or a pin since it can
damage the device.
•
If you see the
Initialize System?
message, press
or touch
or
to abort initialization and customization.
•
If you confirm the prompt, the factory defined settings will be
restored, but you can still prevent the deletion of your data by
