49
Problem
Solution
Relative pressure
does not agree
with official
reporting station
Relative pressure refers to sea-level equivalent temperature
and should generally agree closely with the official station. If
there is a disagreement, make sure you are not looking at
absolute pressure, in particular if your station is not near sea
level. Also check at different times due to occasional delays in
updates to the official station.
Redo the pressure calibration procedure described in section 0.
The barometer is only accurate to ± 0.09 inHg (3 hPa) within
the following relative pressure range: 20.67 to 32.50 inHg
(700 – 1,100 hPa), which corresponds to an altitude of 9,000
ft. (2,750 m) down to 2,500 ft. (750 m) below sea level. At
higher altitudes, you should expect a possible lesser accuracy
and non-linearity effects in the error (the calibration offset
only allows for a partially linear correction).
Time is incorrect
Make sure your time zone and daylight savings time setting is
correct (even when connected to the Internet via Wi-Fi this is
needed).
Data not
reporting to
Wunderground.c
om
Confirm your station ID is correct. The station ID is all caps,
and the most common issue is substituting a capital letter O for
a 0 (zero) or vice versa. Please note the digit 0 can only occur
in the last part of the station ID (which is a station number in a
city). Example, KAZPHOEN11, not KAZPH0EN11
If there's a number
"1" on the station key, try to input the
lower case of letter "L" to replace it on the app.
Confirm that your password (also called: key) is correct. It is
the password wunderground.com generated for your station
ID. You can also verify it by logging in to wunderground.com
and looking it up under “My PWS.”
Make sure the date, time and time zone is correct on the WS
View app. If it is not incorrect, you may be reporting data for a
point in the past or future and you may not see it where you
expect it.
Check your router firewall settings. The gateway sends data
via port 80. If you can access other web sites using “http” (not
to be confused with “https”) this setting will be OK.
Summary of Contents for GW1003
Page 33: ...33 Dashboard Graph display ...
Page 34: ...34 List display Weather Map ...
