ECOWITT GW1003, Operation Manual

Page: 25 / 53

25
Wi-Fi (Red): Indicates the status of the Wi-Fi connection.

On (steady): indicates connected to Wi-Fi network; network
communication normal and data uploaded to configured weather
service(s) successfully.

Off (steady): Wi-Fi connection failed.

Flash (slow), indicates connected to Wi-Fi network; network
communication normal, but upload to one or more configured weather
services failed. First confirm Internet access through your router is
functioning, and then check whether the upload server account and
password are correct (use WS View application).

Flash (faster), indicates that Wi-Fi configuration mode is active. Use the
WS View mobile application to complete the configuration.
4.5.2 Button functions
The black button is used for the following two modes:
Wi-Fi Configure Mode: Press and hold the button for about 5 seconds until
the Wi-Fi status LED is flashing rapidly, indicating the gateway is ready for
Wi-Fi configuration.
Reset Mode: Press and hold the button for about 10 seconds will reset the
gateway to factory settings. The history data, Wi-Fi settings, calibration etc.
are all lost and need to be setup again via WS View app.
Note: When powered up, and when there is no valid Wi-Fi configuration
(including very first time), the Wi-Fi status LED will be rapidly flashing. It
means that the gateway is in the Wi-Fi configuration mode. Use the mobile
application to complete the configuration process.
Note: If you purchased optional sensor(s), you can power up the new sensor(s) at
any time and use mobile application’s live data view to confirm whether
the sensor has been added successfully. If this does not appear the case,
also check the “Sensors ID” page to see if the sensor’s ID has been
registered.