© Copyright 2004 - 2020 MAD Design Group. All rights reserved. V1119
ENGLISH
Peninsula
Installation
6. Fix the appliance to the framework with screws using the existing
mounting holes on the appliance flanges. Make sure that the
appliance is level before securing it in place.
7. Remove the red stability brackets.
8. Complete the construction by finishing the wall paneling around the
appliance. (See section on FINISHING INSTRUCTIONS and ensure that
you fully understand where non combustible materials must be used.)
9. Place the burner into position.
10. Remove the dust protective tape that covers the windscreen
mounting slots.
11. If your appliance includes a decorative box on the left / right or both,
insert the internal glass panel by feeding the glass upwards into the
slot then pushing down into the positioned clips.
*Decorative logs must NOT be placed directly over an open flame.
They are designed to sit near heat but not over flames.
12. Insert the full height glass panel into the open end side by inserting
the glass into the opening at the top of the appliance, and lowering it
into the slots in the base until it bottoms out into place.
13.Install the windscreen by inserting the two ends into appropriate
slots in the appliance. Use a small amount of pressure to push the
windscreen in place until it bottoms out into the hidden glass clips.
Repeat the same for the back side windscreen.
WARNING: The glass used is toughened glass - which means it is
stronger than normal glass. Importantly, even though it is stronger,
toughened glass still has weaknesses. The corners and sides are
specific pressure points where it is more fragile and can break if care
is not taken. Glass breaks into many small pieces. Take care to avoid
cuts. We recommend you wear protective gloves when handling glass.
14.Spread the glass charcoal evenly around the appliance tray.
CAUTION: Make sure the burner lid is closed. Keep the glass charcoal
away from the burner flange to avoid glass charcoal from accidentally
going into the burner chamber. Be careful not to scratch the burner.
